PRODUCTS
Wear parts Aggregate Manufacturers – CHOCKY BARS WITH METAL CERAMIC – Jinhua
Wear parts Aggregate Manufacturers – CHOCKY BARS WITH METAL CERAMIC – Jinhua Detail:
This practice is suitable for Chocky bars only.
Note: For severe curves with a radius of less than 305mm, or inside curves, it is advisable to notch the mild steel
backing plate opposite the “V” to assist forming. (Figure A)
The Chocky bar may crack during bending. This is normal.
1. Clean the surface to which chocky bar will be welded.
2. Tack weld one end of the chocky bar(as per the welding procedure) in at least 3 places by 15mm minimum
length per weld(Figure 1)
3. Outside Curves: Hammer down unwelded end of bar with a soft face hammer to bend bar to match mating
radius. (Figure 2)
4. Inside curves: Starting the center strike bar with a soft face hammer to bend bar to match mating radius.
(Figure 3)
5. Cutting Details: High pressure abrasive water jet cutting is the preferred cutting method. Thermal cutting
using an oxyacetylene torch, arc-air or plasma is NOT recommended due to high localized heat input and high
risk of cracking, cutting by abrasive disc is an accepted practice.
Product detail pictures:
Related Product Guide:
"Based on domestic market and expand overseas business" is our improvement strategy for Wear parts Aggregate Manufacturers – CHOCKY BARS WITH METAL CERAMIC – Jinhua , The product will supply to all over the world, such as: Tajikistan, Niger, Finland, In the new century, we promote our enterprise spirit "United, diligent, high efficiency, innovation", and stick to our policy"basing on quality, be enterprising, striking for first class brand". We would take this golden opportunity to create bright future.
By Delia Pesina from Swedish - 2017.06.25 12:48
This manufacturers not only respected our choice and requirements, but also gave us a lot of good suggestions, ultimately， we successfully completed the procurement tasks.
By Joa from Honduras - 2017.01.28 19:59
